Gefen EXT-HDMI1.3-442 User Manual download pdf (Page 13)

IR CHANNEL CONFIGURATION

Setting The IR Channel

Use the following procedure to set the proper IR channel on the 4x2 Switcher for

HDMI 1.3.

1 Press and hold the EDID button.

2 While holding the EDID button, press and release the Reset button. The

input LED indicators, on the front panel, will represent the current IR channel

for the Switcher: A blinking LED corresponds to DIP switch set to the ON

position. An inactive LED corresponds to a DIP switch set to the OFF

position.

In the illustration above, the LED for Input 1 is blinking and the LED for Input

2 is inactive. This indicates that the Switcher is set to IR channel 1.

IMPORTANT: The selected IR channel must be the same as the IR channel

set on the IR Remote Control Unit (see page 9). Refer to the table below for

setting the IR channel.

IR Channel Table

Input LED 1 Input LED 2 IR Channel

OFF OFF 0

OFF ON 1

ON OFF 2

ON ON 3

3 Continue holding the EDID button while pressing and releasing the Reset

button to cycle to the next IR channel.

4 Once the proper IR channel has been selected, release the EDID button.

position

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

No comments

Gefen EXT-HDMI1.3-442 User Manual Page 13