®2x2 Switcherfor HDMI® 1.3EXT-HDMI1.3-242User Manualwww.gefen.com
7IR REMOTE DESCRIPTION1 LED Button Press IndicatorThis LED will be activated momentarily each time a button is pressed.2 Display and Source Selectio
8Installing the IR Remote Control Battery1. Remove the battery cover on the back of the IR Remote Control unit.2. Insert the included battery into t
9IR REMOTE CONFIGURATIONSetting the IR Remote Channel on the RMT-8IRIn the event that IR commands from other remote controls confl ict with the supplie
10IR CHANNEL CONFIGURATIONSetting The IR ChannelUse the following procedure to set the proper IR channel on the 2x2 Switcher for HDMI 1.3.1 Press and
11EDID MANAGEMENTEDID Mode Selection1. EXTERNAL MODE: See page 10 for details on using the External EDID.2. INTERNAL MODE: To use this mode, press the
12EDID MANAGEMENTExternal EDID ManagementThe 2x2 Switcher for HDMI 1.3 features EDID Management. Before the source can send video or audio signals, t
13Video Amplifi er Bandwidth ... 225 MHz Input Video Signal ...
14WARRANTYGefen warrants the equipment it manufactures to be free from defects in material and workmanship.If equipment fails because of such defects
Rev B420600 Nordhoff St., Chatsworth CA 913111-800-545-6900 818-772-9100 fax: 818-772-9120www.gefen.com [email protected] product uses
ASKING FOR ASSISTANCERev B4Technical Support:Telephone (818) 772-9100 (800) 545-6900Fax (818) 772-9120Technical Support Hours:8:00 AM to 5:00 PM
CONTENTS1 Introduction2 Operation Notes3 Features4 Panel Layout5 Panel Descriptions6 Connecting And Operating The 2x2 Switcher For HDMI 1.37 IR Remo
1INTRODUCTIONCongratulations on your purchase of the 2x2 Switcher for HDMI 1.3. Your complete satisfaction is very important to us.GefenGefen delivers
2READ THESE NOTES BEFORE INSTALLING OROPERATING THE 2X2 SWITCHER FOR HDMI 1.3• By default, display information from the display connected to HDMI out
3FEATURESHDMI Features• 225 MHz (up to 12 bit YUV 444 supported @ 1080p) • Deep Color • Dolby TrueHD and DTS-HD Master Audio• Lip-Sync• CEC Pass-Thr
4PANEL LAYOUTFront PanelBack Panel1 2 3 4 567 8 9 10 11
5PANEL DESCRIPTIONS1 Power LED IndicatorThis LED will become active once the included 5V DC power supply is properly connected between the unit and a
6How to Connect the 2x2 Switcher for HDMI 1.31. Connect up to two HDMI source devices to the 2x2 Switcher for HDMI 1.3 using the supplied HDMI cables
Comments to this Manuals