44
RS-232 SERIAL COMMANDS
PCHPOS Command
The PCHPOS command sets the horizontal position of the output signal on the
display.
Syntax:
PCHPOS param1
Parameters:
param1 Value [0...100]
Notes:
The + or - character can also be used, in place of specifying a value, to move the
picture right (+) or left (-) by intervals of 1.
Use ? for param1 to retrieve the current value.
\PCVPOS Command
The PCVPOS command sets the vertical position of the output signal on the
display.
Syntax:
PCVPOS param1
Parameters:
param1 Value [0...100]
Notes:
The + or - character can also be used, in place of specifying a value, to move the
picture up (+) or down (-) by intervals of 1.
Use ? for param1 to retrieve the current value.
Comments to this Manuals