Gefen EXT-DVI-841DL User Manual download pdf (Page 24)

RS-232 SERIAL CONTROL COMMANDS

2. USING SHORT-CUT CHARACTERS TO CHANGE SETTINGS

2.1 HYPERTERMINAL

SETTINGS in Microsoft Windows

First, please setup correct communications by performing these commands (as

shown on the screen shot immediately below):

File->Properties->Setting->ASCII Setup

Also, please be sure to unmark the check box that says “Send line ends with line

feeds.”

2.2 EXAMPLE -- CHANGE THE ROUTED SOURCE

Now you are ready to route Display input sources.

At the Hyperterminal cursor prompt, type the numeral key of the input to switch

to, followed by the ENTER key.

Wait until you see the message “Function Done” on the Display. At this point the

Display should show the correct Source corresponding to the numeral that was

typed.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29

No comments

Gefen EXT-DVI-841DL User Manual Page 24