page | 16
DIP Switch Conguration
HDCP Mode
Some source devices (e.g. computers) will always send HDCP. This may cause problems
in some systems. Set DIP switch 2, on the Sender unit, to the ON (up) position to ignore
detection of an HDCP-compliant display. Otherwise, set DIP switch 2 to the OFF (down)
position.
Description Sender unit Receiver unit
HDCP enabled (default)
• Enables HDCP pass-through.
HDCP disabled
• Disables HDCP pass-through.
• DIP switch 1 must be set to the OFF
position (Internal EDID mode), as shown.
ON SAB
1 2 3 4
ON SAB
1 2 3 4
ON
1 2
ON
1 2
Information
Setting DIP switch 2 to the ON position (HDCP disabled) does not decrypt
HDCP content.
Basic Operation
Basic Operation
Comments to this Manuals