Gefen GTV-ETH-2COAX User Manual download pdf (Page 8)

SENDER PANEL DESCRIPTIONS

Standby Button1.

Pressing this will put the sending unit in standby mode. The unit will not

transfer any information to the receiving unit in this mode. To release

standby mode, simply press the button again.

Ethernet Input Port2.

Connects to the Ethernet source (i.e a router, computer, or Internet

connection) via a standard network cable.

Security/Reset Button3.

Pressing this button for 2 seconds will activate the Automatic Security

Conﬁ guration (please see page 17). Pressing this button for more than 10

seconds will perform a factory reset.

AC Power Cable Input4.

Input for the supplied AC power cable.

Coaxial Output5.

Coaxial output to link the sending and receiving units together. This

connector will support RG-6 and RG-59 cables.

LAN LED6.

This LED will activate when a connection to a valid Ethernet source is

established. It will blink when activity is detected to signify that data is

actively being trafﬁ cked to and from the receiver.

Link LED7.

This LED will activate once a link has been established between the sending

and receiving units. It will blink when activity is detected to signify that data is

actively being trafﬁ cked.

Power LED8.

This LED will activate once the included power supply is properly connected.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 30 31

No comments

Gefen GTV-ETH-2COAX User Manual Page 8