Gefen EXT-HDMI-5BNC User Manual download pdf (Page 11)

How to Connect the HDMI Over RGB

Connect the HDMI source device to the HDMI Over RGB sender unit using 1.

the supplied HDMI cable.

The HDMI Over RGB sender and receiver can be used with either a user 2.

supplied 4 or 5 BNC cable system.

5 BNC Cables

Connect all 5 BNC cables to the R, G, B, C, and RP BNC connectors

between the HDMI Over RGB sender and receiver units.

4 BNC Cables

Connect the 4 BNC cables to the R, G, B, and C BNC connectors between

the HDMI Over RGB sender and receiver units. The RP BNC connector will

not be used and a second power supply (part# EXT-PS52AU) will need to be

purchased and connected to the receiver unit.

Connect the HDMI capable display device to the HDMI Over RGB receiver 3.

unit using a user supplied HDMI cable.

Connect the included 5V DC power adapter to the HDMI Over RGB sender 4.

unit.

NOTE: If using a 4 BNC cable system, a second power supply must be

purchased and connected to the HDMI Over RGB receiver unit.

Power on the display ﬁ rst and then the source.5.

How to Operate the HDMI Over RGB

The HDMI Over RGB does not require any conﬁ guration for standard operation.

IR Repeater Feature

An IR emitter/blaster (sold separately, part# EXT-2IREMIT) is required to send

relayed IR commands to equipment at the sender’s location. Connect the IR

emitter jack to the HDMI Over RGB sender unit and connect the IR “eye” on

or near the IR receiver of the equipment that is intended for control. Point the

equipment’s IR remote at the IR receiver on the HDMI Over RGB receiver unit

and press buttons to relay commands back to the equipment device.

CONNECTING AND OPERATING THE HDMI OVER RGB

1 2 ... 6 7 8 9 10 11 12

No comments

Gefen EXT-HDMI-5BNC User Manual Page 11