Gefen EXT-3GSDI-2-HDMI1.3S User Manual

®3GSDI toHDMI® 1.3 ScalerEXT-3GSDI-2-HDMI1.3SUser Manualwww.gefen.com

Operation of the Scaler is done by IR Remote Control (Gefen part no. EXT-RMT-8HDS-IR, provided with the 3GSDI to HDMI 1.3 Scaler). The remote control

81. Remove battery cover from the back of the included RMT-SHDS-IR remote.2. Verify that DIP switches 1 and 2 are in the down (OFF) position. (See p

9RMT-8HDS-IR REMOTE CONFIGURATIONHow to Resolve IR Code Confl ictsIn the event that IR commands from other remote controls confl ict with the supplied R

CONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALERControlling the 3GSDI to HDMI 1.3 ScalerThe 3GSDI to HDMI 1.3 Scaler has a built in GUI (Graphica

Supported Video and Graphics FormatsThe following table contains all supported video and graphic formats for the Gefen 3GSDI to HDMI 1.3 Scaler. The

CONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALER FormatModeSignal Type1920x1080 24 PsF Video Input1920x1080 23.98 P Video Inpu

CONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALERContains options such as OSD Language (English or French) and Scaler confi guration:General Opt

CONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALERPatternsThe 3GSDI to HDMI 1.3 Scaler has 2 built-in test patterns: Color Bars and Cross Hatch,

CONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALEROutput Formats MenuFigure 7 - OutputThe v

CONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALERThis section of the menu contains all video formats that can be output by the scaler on the

ASKING FOR ASSISTANCERev B5Technical Support:Telephone (818) 772-9100 (800) 545-6900Fax (818) 772-9120Technical Support Hours:8:00 AM to 5:00 PM

17This function allows creation of a custom output. 720p is the default. Check the specifi cations of your output device to ensure compatibility when c

18 Deep ColorCONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALER Input Formats MenuThe handling of video input signals can be confi gured fro

CONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALER19 SDI Input FormatWhen the Scaler sees a valid SD/HD/3G-SDI source as input, the format is dis

20 Clean ApertureCONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALERThe clean aperture size and position can be confi gured. You can set the percent

21 SDI Audio ChannelCONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALER IR Remote ChannelThe Scaler’s IR remote control transmits IR codes on a si

22 Picture Adjustment/Enhancement FunctionsColor Brightness & Contrast AdjustmentsCONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALERThe Scaler

23 Two predefi ned tables are available: Default and sRGB. The user can also defi ne a custom User Table by using commands sent over the USB port via

24 Noise Reduction ControlCONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALERMotion Threshold ControlThe motion threshold can be set from 0 to 15.

25 The RGB output color range may be changed/set from limited (16-235) to full (0-255). The output link confi guration must be set to RGB 4:4:4

26 CONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALERSeveral Aspect Ratio Modes are available. In Full Screen Mode, the Scaler transforms the input

1 Introduction2 Operation Notes3 Features4 Panel Layout5 Panel Descriptions6 Connecting And Operating The 3G-SDI To HDMI Scaler 6 Setting up the Sc

27CONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALERThe Extract command takes a subset (cropping) of the SD/HD/3G-SDI source picture and replicates

28TROUBLESHOOTINGThe power LED is continuously blinking.• First, disconnect all input and output A/V devices from the Scaler, then reset it by removi

TROUBLESHOOTINGDeep color is not working.• Does the display device on the HDMI output support HDMI 1.3 and Deep Color?• Make sure the output link c

30 APPENDIX A: SOFTWARE UPDATESInstalling Software Updates from GefenPeriodic software updates will fi x known technical issues and enhance capabilitie

31APPENDIX B: GAMMA USER TABLE UPDATESThe format of the LUT table defi nition fi le is standard CSV (Comma Separated Values). Each line contains Red, Gr

SPECIFICATIONSMax. image output resolution ... 2048x1080p24Input A/V Bandwidth ...

WARRANTY33Gefen warrants the equipment it manufactures to be free from defects in material and workmanship.If equipment fails because of such defects

Rev B520600 Nordhoff St., Chatsworth CA 913111-800-545-6900 818-772-9100 fax: 818-772-9120www.gefen.com [email protected] product uses

INTRODUCTIONCongratulations on your purchase of the 3GSDI to HDMI 1.3 Scaler. Your complete satisfaction is very important to us.GefenGefen delivers

OPERATION NOTES• The built-in GUI (Graphical User Interface) or On-Screen Display (OSD) provides convenient operation of the Scaler. The supplied IR

Features• View 3G-SDI video directly from a 3G-SDI network scaled onto any HDMI-compliant display at any resolution you choose. • 225 MHz Video Band

PANEL LAYOUTBack46789105 11 12Front3214

1 IR Window (Sensor)Electronic sensor which receives IR commands from the IR Remote Control. 2 Power LED Indicator (Red)Becomes active when power is

CONNECTING AND OPERATING THE 3GSDI TO HDMI 1.3 SCALERSetting up the Scaler for the First Time1. Connect the SD/HD/3G-SDI source(s) to the SDI input(s