Gefen EXT-DVI-16416 User Manual download pdf (Page 39)

Switching and Masking without the Web Interface

The Gefen 16x16 DVI Matrix uses HTML form attributes to communicate to the

box. It uses the ‘method’ attribute with the ‘get’ value to send a command. The

Matrix has a set of values that sends a valid command to perform switching and

masking. If a command is valid, an “OK” message will be displayed. If the com-

mand is invalid, a “FAIL” message will be displayed.

Switching

Below is the syntax for the SWITCH command. The table below lists the only

values that can be entered to perform a successful switch. All values are case-

sensitive.

Syntax

Single Output

http://<matrix IP address>/cgibin.shtml?a=s&o=<output

value>&i=<input value>*

* Brackets should be removed and replaced with values according to the Switch-

ing Table on page 37.

Multiple Outputs

http://<matrix IP address>/cgibin.shtml?a=s&o=<output

value>&o=<output value 2>&o=<output value 3>&o=<output value

n>i=<input value> **

** When working with multiple outputs, a maximum of 16 output ports can be

entered. To specify additional ports to switch, type:

&o=<output value>

Do not use the angled brackets when typing the command.

IP CONTROL

I/O MANAGEMENT WITHOUT THE WEB INTERFACE

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 50 51

No comments

Gefen EXT-DVI-16416 User Manual Page 39