Gefen EXT-DVI-1CAT6-GI User Manual

Audio Embedder 3GSDI EXT-DVI-1CAT6-GIUser ManualDVI over 1 CAT6 w/ Galvanic IsolatorRelease A2*Preferred

DVI over 1 CAT6 w/ Galvanic Isolator1 Getting StartedIntroduction...

page | 2Page TitleIntroductionSender unitDVIover 1 CAT6w/ Galvanic Isolator S5V DCPower DVI InLinkEXT-DVI-1CAT6-GISGefenDVIover 1 CAT6w/ Galvanic Isol

page | 3Page TitleIntroductionID Name Description1 Link Connect a CAT-5e cable (or better) from this port to the Link port on the Receiver unit. 2 5V

page | 4Page TitleIntroductionGetting StartedGetting StartedReceiver unitDVIover 1 CAT6w/ Galvanic Isolator R5V DCPower DVI Out EQLinkEXT-DVI-1CAT6-GI

page | 5Page TitleIntroductionGetting StartedID Name Description1 Link Connect a CAT-5e cable (or better) from this port to the Link port on the Sende

page | 6Connection Instructions1. Connect the included DVI cable from the imaging source (e.g. camera) to the DVI In port on the Sender unit.2. Conn

DVI over 1 CAT6 w/ Galvanic Isolator2 Basic OperationDIP Switch Conguration ...

ii1. Read these instructions.2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.5. Do not use this product near water.6.

page | 10DIP Switch CongurationBasic OperationBasic OperationOn the bottom panel of the Sender unit is a bank of 4 DIP switches. Remove the piece of

page | 11EDID ManagementThe DVI over 1 CAT6 w/ Galvanic Isolator can be switched between two EDID modes: Internal or Pass-through. After changing D

page | 12The Receiver unit of the DVI over 1 CAT6 w/ Galvanic Isolator has a trim pot that is used to equalize the output signal, compensating for ext

DVI over 1 CAT6 w/ Galvanic Isolator3 AppendixSurface Mounting Instructions ...

page | 16The Sender and Receiver units can be mounted on any at surface, as shown below (screws not included). There should be an inch or two of cle

page | 17SpecicationsAppendixConnectors & IndicatorsVideo Input (Sender) • 1 x DVI 29-pin, female (digital only)Video Output (Receiver) • 1 x

20600 Nordhoff St., Chatsworth CA 913111-800-545-6900 818-772-9100 fax: 818-772-9120www.gefen.com [email protected] it. Switch it. S

iiiGefen warrants the equipment it manufactures to be free from defects in material and workmanship.If equipment fails because of such defects and Gef

ivTechnical Support(818) 772-9100 (800) 545-6900 8:00 AM to 5:00 PM Monday - Friday, Pacic TimeFax(818) [email protected]://www.

v• Always connect a bonding wire between an approved safety ground and the grounding screw on the chassis.• Electromagnetic Interference This produc

viFeatures and Packing ListFeatures• Compliant with Medical Standards EN60601-1 and EN60601-1-2, 3rd Edition• Extends DVI up to 132 feet (40 meters)

viiiTable of Contents1 Getting StartedIntroduction.......