Gefen EXT-WHDMI User Manual download pdf (Page 12)

1 Power LED Indicator

This LED will become active once the included 5V DC power adapter is properly

connected.

2 Video LED Indicator

This LED will be active while video is actively being transmitted between the

sending and receiving units.

3 Link LED Indicator

This LED will become active once a solid link has been established between the

sending and receiving units. If the distance between the units are too great and

a link can not be established, shorten the distance between the units until the

link indicator activates.

4 Receiving Antennas

These antennas must be in line of sight with the transmitting antenna for best

possible performance. Do not disconnect or re-orient the position of these

antennas. Doing so may cause unexpected operation and may produce a

complete loss of signal.

5 5V DC Power Input

Connect the included 5V DC power supply to this input and the power outlet.

6 HDMI Output

Connect the viewing display to this output port. If the detected display is a DVI

type, the analog audio inputs on the Gefen Wireless for HDMI UWB will be

used for the audio input. The analog audio output ports will also be active on the

receiving unit.

7 Stereo Analog Audio Output

The stereo analog audio output ports will always be active when the audio

source is 2 channel audio. When multi-channel audio is used, these outputs will

be disabled. This output will be active when a DVI type display is detected on

the HDMI output port and will use audio from the analog stereo input jacks on

the sender.

8 IR Receiver Extension Port

An optional IR receiver extension is connected to this port for use with the IR

repeater feature. IR commands that are received through the IR receiver will be

transmitted back to the source for output through attached IR blaster.

RECEIVER PANEL DESCRIPTIONS

1 2 ... 7 8 9 10 11 12 13 14 15 16 17

No comments

Gefen EXT-WHDMI User Manual Page 12